DKS17DS Car Air Conditioning Compressor 168663 140872 For Ford Mustang5.8 2010-2014 WXFD134

DKS17DS Car Air Conditioning Compressor 168663 140872 For Ford Mustang5.8 2010-2014 WXFD134
 

Your car's air conditioning compressor pumps refrigerant to provide cool, comfortable air to your vehicle. Without refrigerant circulating, your car won't be able to cool the interior, causing the air conditioning system to produce only warm air.
 
Parameter:

Goods Picture

 
Compressors :
 
1) Rotary Vane - Panasonic
Rotary vane compressors consist of a rotor with three or four vanes and a carefully shaped rotor housing. As the compressor shaft rotates, the vanes and housing form chambers.
 
The R134a is drawn through the suction port into these chambers, which become smaller as the rotor turns. The discharge port is located at the point where the gas is fully compressed.The vanes are sealed against the rotor housing by centrifugal force and lubricating oil. The oil sump and oil pump are located on the discharge side, so that the high pressure forces oil through the oil pump and then onto the base of the vanes keeping them sealed against the rotor housing.
 
During idle an occasional vane noise from the compressor may be heard. This is due to the time taken for lubricating oil to circulate through the A/C system.
 
2)Scroll type - Sanden
This compressor uses a unique design with two scrolls, one fixed and one is movable, both are inter-leaved.The movable spiral is able to ORBIT or oscillate without actually fully rotating. The movable scroll is connected to the input shaft via a concentric bearing.
As the movable spiral oscillates within the fixed spiral, a number of pockets are formed between the spiral. As these pockets decrease in size the refrigerant is squeezed, the pressure increases and is discharged through a reed valve at the discharge port in the rear section of the compressor.
 
3)Variable stroke - Harrison V5
The Delphi (Harrison) V5 compressor is a non-cycling variable displacement compressor.
The compressor varies displacement to control capacity to meet A/C system demand at all operating conditions. The compressor features a variable angle wobble plate in five (V5) cylinder axial piston design.
Displacement is controlled by a bellows actuated control valve located in the rear cylinder head. This control valve senses and responds to the system suction pressure or A/C system demand.
Through regulation of compressor crankcase pressure, the wobble plate angle, and therefore compressor displacement is variable.
In general, the compressor discharge pressure is much greater than the compressor crankcase. Which is greater than or equal to the compressor suction pressure.
 
 
 
 
Compressors and Mount & Drive:
 
Mount & Drive
Consists of a bracket to mount the compressor to the engine, a belt idler pulley, compressor drive belt and possibly and extra drive pulley for the crankshaft.
 
Compressor Mount
Manufactured of either plate, cast iron, steel or aluminium, this bracket should exhibit
excellent noise absorption qualities especially if using a piston type compressor.
 
Idler Pulley
A small pulley normally used in conjunction with a belt adjusting mechanism, also used when a belt has a long distance between pulleys to absorb belt vibrations.
 
Drive Pulley
Some vehicles do not have an extra pulley to accommodate an A/C drive belt, in these
cases an extra pulley is bolted onto the existing crankshaft pulley.
 
 

Warehouse /Delivery